+50VDC
0VDC
TO LASER (RF PSU)
Figure 31 - DC cable connections
DC power cables of the correct specification can be supplied by Luxinar.
Cooling system connections
The power supply requires a liquid cooling source. It is recommended that it is connected in series
with the laser system cooling circuit. The coolant connections are located on the rear of the power
supply. See section
.
Figure 32 - Coolant connectors
The coolant inlet and outlet connectors are labelled as shown below.
Coolant IN
Coolant OUT
D.1.4. Operation
The power supply has no user controls. When powered up, it will automatically carry out diagnostic
checks. If no faults are detected, the status indicators on the front panel all display green and the DC
output is enabled.
If faults are detected, one or more status indicators will be off or displaying red/amber. For a status
indicator explanation, refer to the following table.
D. DC power supply options
54
906-0227-00 REV 1
Summary of Contents for SR 10 AOM
