Figure 34 - Overall dimensions
Table 24 - Electrical specifications
DC SR 25
Input voltage range
230VAC ± 10%
Mains input frequency range
50–60Hz
Mains input fuse rating
32A
AC inrush current (max.)
40A
Output voltage (DC)
50 ± 1V
Output current
120A
Power factor
—
Power consumption (max.)
6kW at pulsed full power
D.2.3. Installation
Mains AC power connections
Important!
Under certain conditions, it may be possible for high voltage and current cables to emit noise
energy levels that may interfere with control signal cables. To eliminate the possibility of
interference, cables carrying control signals should be routed along a different path to power
cables.
The power supply is provided with a 6mm² mains supply cable. If this cable needs to be replaced
with a longer cable, ensure the replacement cable is of the correct rating for the power supply.
Note: The
L1
and
L2
terminals are internally protected by a 40A type B2 miniature circuit breaker.
The circuit breaker is accessible after removing the cover plate on the side of the power supply.
There are two T1A 20 x 5mm fuses for the internal fan and user low flow 50A supply in fuse holders
on the side panel.
906-0227-00 REV 1
57
D. DC power supply options
Summary of Contents for SR 10 AOM
