LuxHome LHC100SK, Instruction Manual

Page: 24 / 43

4
The voice dialler will call each active number in the dialling sequence in turn. When a call is answered
the pre-recorded alarm message will be replayed. If the call is unanswered or an acknowledgement
signal is not received from the number called, (i.e. by pressing the button on the telephone keypad)
the next number in the sequence will be called.
Press
ESC
!
to exit voice dialler test.
Factory Defaults
Item Defaut
User Access Code 134
Alarm Duration 3 minutes
Hardwired Siren Equal to Alarm Duration
Zone Operating Mode Zones 1-6: Intruder
Part-Arm
Zones 1: Disabled
Zones ,3,4,5,6: Active
Instant/Delay
Zone 1: Delay
Zones -6: Instant
Entry/Exit Delay 30s
Entry/Exit Warning Tone On
Zone Lockout On
Jamming Detection On
Phone Numbers Not programmed
Message Play Time 70s
Alarm Message Not programmed
Call Routing All numbers disabled
Call Attempts 3
Dial Method Tone/DTMF
Reset Factory Default Conditions
1. Press
,
? ? ? ?
,
User Access Code
to place the system in Test Mode.
. Undo the Control Panel cover fixing screws and open the cover.
3. Switch OFF the mains supply to the plug-in PSU Adaptor.
4. Remove either back-up battery and disconnect the battery leads.
5. Set jumper link P1 to the ON position.
6. Reconnect the battery leads and replace the back- up battery in position.
7. The Control Panel will now set itself with all factory default settings. This takes approx. 10 seconds.
8. Reconnect and switch On the supply to the PSU adaptor.
9. Reset jumper link P1 into the OFF position.
10. Close the Control Panel cover and refit the fixing screws.