LuxHome LHC100SK, Instruction Manual

Page: 27 / 43

7
Alarm Duration
Default setting: 3 minutes
Press
6 5
The zone LED corresponding to the current setting will illuminate.
0 no alarm
1 1 minute
minutes
3 3 minutes
4 5 minutes
5 10 minutes
Press the key corresponding to the required alarm period, the corresponding zone LED will illuminate
as the setting is changed.
Note: When set to ‘No alarm’ the Siren will sound for approx. 10 seconds if an alarm condition is
initiated.
Press
,
1 2 3 4
,
to save the new setting and return to programming mode.
Press
ESC
!
to return to programming mode without saving.
Note: Following initiation of a Full Alarm condition the External Siren will continue to sound until
either the system is Disarmed; or the Control Panel Alarm Duration Time expires; or if activated
until the 3 minute alarm time limit of the external Siren expires; whichever occurs first.
Part-Arm
Default setting: Zone 1 Disabled
Zones -6 Active
Press
6
The zone LED corresponding to the zones currently active during Part-Arm mode will be illuminated.
LED’s for zones disabled during PART-ARM will be OFF.
LED ON Zone enabled in Part-Arm
LED OFF Zone disabled in Part-Arm
To change the setting of a zone press the button corresponding to the zone number. The zone will
toggle between the two modes each time the button is pressed.
Press
,
1 2 3 4
,
to save the new setting and return to programming mode.
Press
ESC
!
to return to programming mode without saving.