ϯ
&/Z^dE'>WZK:d/KE
>ƵŵŝŽƌĞ
^>͗ϭ͗ϭ
ƵŶŝƚƐ͗ŵŵŝŶĐŚ
$
$
%
%
&
&
'
'
(
(
)
)
>hϬϭϬϬϬϳϰ
n
m
Wire*
Connection
Green/Yellow
AC Ground
Blue
AC Neutral
Brown
AC Line
* International (Harmonised) Standard
The LumiCore requires standard AC power distribution from 100-240VAC, 50/60Hz.
The mating Neutrik powerCON TRUE1 connector is supplied; however, you will need to purchase or
construct a cable appropriate for your application.
When installing a new connector please refer to the following wire colour code reference:
Alternatively, the LumiCore series are 802.3af compliant (PoE), so that each LumiCore will act as a PD
(Powered Device) and can be powered by any compliant PSE (Power Sourcing Equipment) such as
Ethernet switch, midspan and PoE injector. All models can only be powered with PoE via ETH2!
If both AC power and PoE are used the AC power supply will be prioritised, but the PoE will seamlessly take
over if the AC power fails.
2.3 Connection to the network
To get the LumiCore online in your system, connect either port ETH1 or ETH2 to a computer, or to a port of
an Ethernet switch.
Only port ETH2 on the rear of the unit can be used to power the unit through PoE. Check the port labelling
for a better identification.
2.2 Power up the device
The LumiCore can be powered with a power cable fitted with a Neutrik powerCON TRUE1 connector
(M)
(please contact your local dealer if you do not have a suitable power cable at hand). The device will
automatically switch on. To shut it down after use, just un-plug the power cable again. The LumiCore can
also be powered with PoE
(N)
.
2 | InstallatIon
9
