DP16-910B-VS 12
OPERATION
Operation
–Practise on waste material first to learn how to
operating the machine.
–When drilling all the way through a piece of
material, adjust the table so the drill is aligned
with the centre of the table. Secure the work
piece securely an unsecured work piece results
in a rough drilling hole and increases the risk of
the drill bit breaking.
–Use a piece of waste wood beneath your
workpiece to reduce the risk of the work piece
splinting and protect the drill tip.
–Use the lift handles to slowly bring the drill
downwards and slowly feed the drill into the
workpiece.
–Drill extra slowly when the drill bit is about to
break through the workpiece to prevent
splintering.
Switching ON/OFF
Lift the safety stop case and engage the green
start button.
Simply press the Red button to stop the machine
Light & dual laser guide system
WARNING! Do not look directly at the laser
beams. Do not aim the laser beams at any
person or any object other than your
workpiece.
If you desire using the dual laser guides, use the
laser switch to turn them On or Off. If an
adjustment to the laser guides are necessary ,
proceed as follows;
1) Loosen set screw (one set screw for each
laser) and then slightly turn laser guide in either
direction, this will reposition the laser beams
Trajectory , adjust the position of the laser
guides this way until both beams intersect at the
point where the drill bit touches the workpiece.
Retighten set screw after each adjustment.
The light ON-OFF switch turns ON and OFF a
halogen light bulb which is found inside the head
casting.
Tilting the table
To use the table in a bevel position, loosen the
bevel lock bolt with an adjustable wrench. Tilt the
table to the desired angle by reading the bevel
scale on the table support. Retighten the bevel
lock bolt.
Adjustment the extension table
To use the extension table, loosen the lock nut
with pull the extension table. Retighten the lock
nut.
Summary of Contents for DP16-910B-VS
Page 23: ...DP16 910B VS 21 Parts Diagram...
