DP16-910B-VS 10
ADJUSTMENTS
WARNING!
For your own safety, turn the switch OFF
and remove the plug from the power source before
making any adjustements. To avoid injury from
thrown parts due to the spring release, follow
instructions carefully and wear safety glasses.
Installing drill bits
Insert the drill bit into the chuck far enough to obtain
the maximum gripping of the chuck jaws. The chuck
jaws are approximately 1” long. When using a small
drill bit, do not insert it so far that the jaws touch the
flutes (spiral grooves) of the bit.
Make sure the drill bit is centered in the chuck before
tightening the chuck with the key. Tighten the drill bit
well, so that it doesn’t slip while drilling. Turn the
chuck key clockwise to tighten, counter clockwise to
loosen.
Drilling to a specific depth
To drill a blind hole(not all the way through) to a
given depth, proceed as follows.
1.Mark the depth of the hole on the workpiece.
2.Loosen the depth scale lock knob.
3.With the switch OFF, bring the drill bit down
until the tip of the lips of the drill bit are even
with the mark.
4.Turn the depth scale counterclockwise until it
stops moving.
5.Tighten the depth scale lock knob.
6. The drill bit will stop at this depth until the
depth scale is readjusted.
Another way-depth scale
1.With the power OFF, loosen the depth scale lock
knob
2.Place workpiece on table. Adjust table until the
tip of the drill is just a little above the top of the
workpiece.
3.Turn the depth scale clockwise until the depth
scale indicator points to the desired drilling depth
on the scale.
4.Tighten the depth scale lock knob.
5.The chuck or drill will now be stopped after
traveling downward the distance selected on the
depth scale.
Summary of Contents for DP16-910B-VS
Page 23: ...DP16 910B VS 21 Parts Diagram...
