Lukhan LK-B10, Command Manual, Page: 51 / 135

50
f Command - Cut Position
Description Use this command on an in di vid ual printer to
pro vide pre ci sion cut place ment to:
• Compensate for small sensor to cut ter po si-
tion differences on a printer by printer basis.
•
Fine-tune the cut po sition to com pensate for
dif fer ences in me dia.
Mobile print ers, such as the printer, ig nore this
com mand.
Syntax
fp
1
Parameters
p
1
= Cut po sition in dex mea sured in dots.
Acceptable values: 070 to 130. The de -
fault value is 100.
When us ing the la bel liner cut ter op tion, the
printer will advance each printed label to the ap -
pro pri ate pro grammed off set cut po si tion,
between labels, before cutting. Due to media
differences, the printer may not accurately
position the labels before cutting, causing the
cutter to cut the label instead of the liner.
The printer’s cutter is not de signed to cut la bels.
Labels have adhesive that may in terfere with the
proper op eration of the cut ter.
Only cut la bel liner and tag stock and do not ex ceed
the spec ified me dia den sity and thickness of the
cutter.
If the cut po sition causes the la bel just printed to
be cut, in crease the cut po sition in dex value
(>100). If the cut po sition causes the la bel fol -
lowing the one just printed to be cut, de crease
the cut po sition in dex value (<100).