Installation Instructions
3-4
Issue 1 August 1998
4. Power up the system:
a. Reconnect the power cord.
b. If you have a 5-Slot carrier, move the carrier's On/Off switch to the
“On” position (“—”).
5. Check that the green light on the front of each module is lit:
a. If a single light is out, power down the system, reseat the module,
then power up the system.
If multiple lights are out, power down the system, reseat the leftmost
module that has a light out, then power up the system.
b. If the lights are still out, in the continental U. S., call the Lucent
Technologies hotline at 1 800 628-2888 for support. Outside the
continental U.S., contact your Lucent Technologies Representative
or local Authorized Dealer.
6. If you have a 2-Slot carrier or a standalone configuration, you are finished
with this procedure. If you have a 5-Slot carrier, continue with Step 6A.
a. Make sure all modules are seated properly. The cover will not fit if
the modules are not seated properly.
b. To replace the cover, grasp it by its upper edges and hold it
squarely over the control unit.
c. Place the cover over the modules and make sure it fits firmly in
place.
d. Tighten the screw on the lower front cover.
Figure 3-4.
Closing Cover of PARTNER ACS 5-Slot Carrier
PFT
PFT
E
X
T
E
N
S
I
O
N
S
L
I
N
E
S
PFT
PFT
E
X
T
E
N
S
I
O
N
S
L
I
N
E
S
PFT
L
I
N
E
S
MUSIC
ON
HOLD
VOL
PAGE
1
2
3
4
16
17
18
19
20
21
15
10
11
12
13
14
MODULE
206
MODULE
206
PROCESSOR
MODULE
PFT
L
I
N
E
S
5
6
MODULE
206
MODULE
206
PA
RT
NE
R P
lus
Screw
