Lucent Technologies Lineage
®
2000 ECS/GPS Battery Plant J85500G-2
3 - 8 Engineering, Planning and Ordering
Issue 6 May 1999
The sum of the normal and the recharge rectifier capacities is
called the plant charge capacity.
The recharge current is a function of the recharge time and
voltage. For example, increasing the plant voltage will, within
limitations, decrease the necessary recharge time, but this calls
for more current. Increasing the plant voltage after a discharge is
also recommended by some battery vendors to assure that all
cells charge equally for maximum life. Although these two
charging methods are essentially the same, they are usually
called by different names. The former process is usually called
boost charging, while the latter is called equalize charging. For
the purposes of this manual, the term “Equalize” is used to
indicate boost or equalize charging. Refer to the battery
manufacturer’s recommendations on equalize charging.
The recharging requirement is determined by customer practices
and is usually specified as a maximum time to reach a minimum
percent of full capacity, for example, at least 90% capacity in no
more than 24 hours.
15. Maximum recharge time: ____ hours
16. Percent of full capacity after recharge time (15): ____ %
Refer to the Battery manual or other documentation to calculate
the required recharge current to meet the requirements of (15)
and (16). The recharge voltage (13) will be needed for this
calculation.
17. Minimum recharge current: ____ amperes
Recharge factor is a term that is sometimes used to describe
available recharge capacity. The recharge factor is the total
charge current divided by the List 1 drain. Typical recharge
factors range from 1.20 to 1.50.
18. Minimum recharge factor: ____
The minimum initial rectifier requirement for float operation is
derived from the Plant List 1 Drains calculated in Table 3-A.
Customer practices may dictate any combination of the
following rectifier engineering conventions.
