INSTALLATION
Lucent PARTNER System Applications
3 Connect the power cord.
Plug the AC power adapter into an electrical outlet and the DC connector to
the back of the base unit. Make sure that the electrical outlet is not controlled
by a wall switch.
CAUTION: Use only the AC power adapter supplied with this
telephone. This is a Class 2 AC adapter, specifically designed for
use with the BC901.
NOTE: Connect power to the base unit before placing the handset in the
cradle.
4
5
6
Set the dial mode switch.
If you have touch tone service on your phone line, set the switch located
on the back of the base to TONE. If you have rotary service, set the switch
to PULSE.
Charge the handset batteries before use.
The batteries recharge automatically whenever the handset is in the powered
base unit cradle. The batteries must be charged for 24 hours before using
your phone for the first time.
Check for dial tone.
After the batteries are charged, pick up the handset and press [
PHONE
]. The
PHONE indicator should light up, and you should hear a dial tone. If not,
see “In Case of Difficulty.”
CAUTION:
1
2
3
4
Never install telephone wiring during a lightning storm.
Never install telephone jacks in wet locations unless the jack is specifically
designed for wet locations.
Never touch uninstalled telephone wires or terminals unless the telephone
line has been disconnected at the network interface.
Use caution when installing or modifying telephone lines.
5
