7
When the monitor is turned on, it will display three dashes (---)
(see Figure 4-1)
for both wheel locations, if you have installed
the optional exterior stick-on warning light, you will see the red
light flash three times and then pause. This will repeat until the
sensor has checked in and is recognized by the monitor. until
the monitor has received a signal from each wheel sensor.
1. Display
- The monitor will display
on
(see Figure 4-2)
when:
The sensors have checked in with the monitor and the signals are received and the air
pressures are within the programmed range, which is within the 12.5% range of the
baseline air pressure (set at 35 psi for Front and Rear at the factory).
If the air pressure is not within the 12.5% range of the baseline pressure a warning will occur
(See Alert mode this Section B)
.
It could take up to six (6) minutes for the monitor to receive the updated signal from
the sensors once the monitor has been activated.
Figure 4-2
Figure 4-3
2. Buttons
-
on
is the normal display when the tires are within the proper air pressure range.
The monitor will display
on
until either the S or P buttons have been pressed.
Pressing the P button will cause the backlight to come on and the monitor to display the
present Air pressure in turn for each tire position for
3 seconds during a 30 second
interval
.
Pressing the S button will cause the backlight to come on and will display the pressure for
the front tire position. Pressing the S button again will display the rear tire position
(see
Figure 4-3)
A third press of the S button will cause the monitor to display the on
as it displays in the
normal operation mode
(Figure 4-2)
.
Function and Operation
A. Normal Operation
Figure 4-1
7