Function and Operation
Look at the sensor and write down the last three digits of the sensor ID code as shown in
Figure 5-3
If you are replacing a sensor, please write down this new sensor ID code on
the front page of the manual to replace the ID code of the sensor being replaced.
.
Last three digits
Figure 5-3
a. In Normal Operation mode, press P button for
5 seconds
to
enter the programming mode, as shown in
Figure 5-4
.
b. Press P to start to program the first digit. The left digit of the
LCD display will begin to flash.
c. Press the S button to adjust the digit to the desired number and
press the P button again to confirm it, as shown in
Figure 5-5
.
d. At this time, the second digit will flash, press the S button to
adjust the digit and press P again to confirm it, as shown in
Figure 5-6
.
e. The third digit will flash next. Press S to adjust the digit, as
shown in
Figure 5-6
.
f. When the third digit of the Sensor ID Code for the front wheel
has been adjusted in
Figure 5-7
, press the P button to return to
the first digit. The system will repeat the above steps. The user
can re-set/adjust the ID code again if needed.
g. Press the P button for 5 seconds. All of the 3 adjusted digits
will be saved as entered and the screen will shift to the sensor
ID programming mode for the other wheel. The process can be
repeated if both sensors need to be entered.
h. You will now move into the Baseline Air Pressure Programming
mode.
11