Function and Operation
2. Baseline Air Pressure Programming
NOTE: This section will be entered automatically when the P button is pressed for 5
seconds to enter the program mode when sensors are already programmed to the
monitor.
P
P
The baseline pressure has been set in the factory at 35-psi.
We recommend that you set
the baseline pressure at the same pressure as your recommended Manufacturers
Operating Tire Pressures.
If you want to
change
the baseline pressure, or a new sensor is
programmed, then follow the procedure below.
NOTE: To skip this section you will need to press the button until the pressure for the
front tire flashes twice and moves to the rear tire position. Press the button
until the pressure for the rear tire flashes twice and moves to the Delete Sensor
section.
F-d
will be displayed.
***The same process is used to program both the baseline air pressure and the ID Code.***
12