Function and Operation
3. Sensor Deletion
NOTE: To enter directly into this section you must press the P button for 5 seconds then
press the P button again until the pressure flashes twice for the front tire. Then
press the P button again until the pressure for the rear tire flashes twice and a F-d
is displayed. You will now be in the sensor delete mode.
NOTE: P
(To skip this section and go to Pressure Unit Programming, press the
button
momentarily, a pressure unit that has previously been selected will be displayed.)
(a). The mode for DELETING the sensor on the front wheel will be
displayed first (see Figure 7-1).
(b). The user can Press the S button to shift the mode to the rear
Wheel to DELETE the sensor (see Figure 7-2).
(c). Choose the wheel position that you want to DELETE the sensor.
Press the P button for 5 seconds to DELETE the sensor and
the screen will shift to the Sensor ID Programming interface of
This sensor automatically.
4. Pressure Unit Programming (Preset from the factory for PSI)
NOTE: To enter directly into this section you must press the P button for 5 seconds then
press the P button again until the pressure flashes twice for the front tire. Then
press the P button again until the pressure for the rear tire flashes twice and a F-d
is displayed. Press the P button once more to enter the Pressure Unit Programming
mode. A pressure unit of measure will be displayed.
NOTE:
If you do not want to change the Pressure Unit Programming, press the P button
briefly. The screen will then show
END
. Press the P button again briefly and
you will exit the Programming mode and return to the Normal Operation Mode.
13
Figure 7-1
Figure 7-2