When the monitor is connected to a non-switched circuit the monitor will draw a very small
amount of current all the time. Leaving the monitor turned on a month at a time without charging
the battery should not cause a complete discharge of the battery. However, periodic checks
should still occur to make sure the battery continues to maintain a charge.
Conduct a regular visual inspection of the motorcycle's tires.
The sensors are not a
substitute for proper tire maintenance and it is the user's responsibility to maintain proper
amounts of tire pressure and respond accordingly to warnings and alerts.
Low tire pressure
is not the only problem associated with tires. Therefore, symptoms such as bulges, uneven tread,
abnormal noise, etc. should
immediately
be brought to the attention of a professional.
B. Sensors
REPLACING RUBBER VALVE STEMS WITH METAL VALVE STEMS IS HIGHLY
RECOMMENDED FOR EITHER INSTALLATION METHOD.
1. Outside the Wheel Installation
This is the only method that can be used for wheels using an inner tube.
a. Screw the sensor labeled
F
onto the Front tire valve-stem. Screw the sensor labeled
R
to the Rear tire valve stem.
b.
Check for clearance between the sensor and components around the wheel location
for any interference with the sensor.
3
Installation