Function and Operation
C. Programming Modes
Your DORAN
360M
comes already programmed and the baseline pressures for both Front and
Rear tires are both set at 35 psi. We recommend that you set the baseline pressure at the same
pressure as your recommended Manufacturers Operating Tire Pressures (see Baseline Air
Pressure Programming on page 12).
The National Highway and Traffic Safety Administration considers a tire flat when the
pressure is 25% below the tire manufacturers recommended operating pressure.
The DORAN
360M
allows you to:
Program a Sensor
Delete a Sensor
Set a Baseline Pressure
Change unit of Measure from psi to Bar or kPA
(Note: the programming mode requires that the operator move sequentially through the
following steps.)
Note: The
P
and
S
used to identify the buttons are only identifiers. They do not hold a significant
value or meaning.
(
If sensors are already programmed to the monitor this section
will be bypassed and you will go into Baseline Air Pressure Programming
when P is
pressed for 5 seconds to enter into the Programming Modes.
)
1. Programming a Sensor
If you need to install a new sensor to a wheel that already has a sensor programmed to it, you
will need to delete the existing sensor before a new sensor can be programmed (See item 3. in
this Section
Sensor Deletion
). When the monitor has been turned ON and the monitor has
not yet received the new sensor signals or they have been DELETED from the monitor it will
display nsP
(
see Figure 5-1 and 5-2
) for
No Sensor Programmed
.
Figure 5-1
Figure 5-2
10