Loren Cook HVAD 2020, Installation & Operation Manual

Page: 28 / 40

28
1. Remove light kit from box.
2. Using a Phillips screwdriver, remove the four - #6 x 3/8 screws
(EN022X0402) and the two electrical box clips (EN562X2490)
to free the LED panel light (EN562X2475) from the electrical
box (EN562X2480). Inside, there will be three #8 x 3/8 pan
head machine screws (EN823X6121).
3. Direct the LED power wire on the bottom of the motor assembly
through the electrical box (EN562X2480). Mount the electrical
box (EN562X2480) to the bottom of the motor assembly using
the three #8 x 3/8 pan head machine screws (EN823X6121)
ensuring wiring is not compromised.
4. Plug the LED panel light into the power wire.
5. Install the four - #6 x 3/8 screws (EN022X0402) and the two
electrical box clips (EN562X2490) to secure the LED panel light
(EN562X2475) to the electrical box (EN562X2480) in the same
manner it was packaged.