Setup and transport
- 40 -
10.13
10 Setup and transport
Danger of injury due to the de-
vice falling over and crashing.
When transporting using mechani
-
cal lifting equipment (e.g. crane,
etc.), only the hoisting points
shown here may be used. Use
suitable load-carrying equipment.
Each lifting point must be loaded
separately. Do
NOT
, for example
put one load strap through both
handles, as this could lead them
to be pulled together and cause
breakage!!
Do not use a fork-lift truck or simi
-
lar device to lift the machine by its
housing.
Remove the gas cylinder from the
welding machine before transpor
-
tation .
The machine must be transported
or set up only on firm, level sur
-
faces. The maximum admissible
angle of inclination for setting up or
transporting is 10°.
minimum
1,22 m
Lifting point for 4-point hoisting of the
M-Pro
Summary of Contents for M-Pro Performance M 200 CuSi
Page 87: ...Puesta en funcionamiento 87 10 13 ...
Page 293: ... 293 10 13 ...
Page 315: ...Antes de colocar em funcionamento 315 10 13 ...
