LORCH M-Pro Performance M 200 CuSi, Operation Manual

Page: 47 / 340

Start-up
- 47 - 10.13
9
Main switch
for turning the welding machine ON
and OFF.
45 Turning knob for setting material
thickness/welding voltage/welding
step.
46
Key button secondary parameter
to access the secondary parameter
menu. When within this menue this
key serves to end it.
47
Trigger Mode
to select 2-stroke, 4-stroke, spot weld-
ing or interval mode.
48
Key button menu
to access the main menu. Pressing
this key will move one level back.
49
Graphic display
displays all information in clear text.
50
Key Tiptronic/characteristics
direct access to the Tiptronic menu
alt. characteristics menu (if Tiptronic is
switched off).
51
Key Secondary parameter
access the secondary parameter di
-
rectly. Within the menu press this key
to end menu.
52
Operation knob Menu
Turning knob wire feed serves to:

select menu (turn)

confirm menu option (press)

setting wire feed

setting secondary parameter
55
Display mode
displays the selected mode by sym
-
bol.
56
Display characteristics
displays the set characteristic line.
57
Display Tiptronic-Job
if the job no. is followed by an asterisk
(*) on the display, a min. parameter of
a saved job has been changed.
58
Dispay wire feed correction
displays the wire feed as correction
value differing from the characteristic
line in %.
59
Display wire feed
displays the actual wire feed speed in
m/min.
60 Display welding step
displays the selected welding step.
61
Display material thickness
displays the selected material thick
-
ness of the workpiece in mm.
62
Display welding voltage
displays the selected welding voltage
in Volt.
13.2 Start-up
Â
Select with mode key 47 the 2-stroke
mode.
Â
Press key characteristics 50 to enter
menu characteristics.
Â
Set matching charateristic line (material-
gas-wire combination) by turning opera
-
tion knob 52.
Â
Confirm the characteristic line by press
-
ing operation knob 52.
Â
Press operation knob 52 again to end
menu and return to standard display.
Â
Set the required material thickness alt.
welding step by using turning knob 45.
9
The machine is ready for welding.
‰
Use operation knob 52 to correct the wire
feed if needed.