14
5. Operating the Cobra 3.1
5.4.3 Operating via Analogue
Fig. 5 Analogue Mode active
Input voltage between 0 and 10 V.
If the voltage is higher than 1 V, the
machine will be controlled via analogue,
provided that neither DMX nor Ethernet
signal is present.
Fig. 6 Select Analog Mode - Direct
Fig. 7 Select Analog Mode - Latched
Connect your cable or radio remote to the “analogue in“ at the
Cobra 3.1
.
The
ANALOG
-Button at the main screen shows the voltage and the selected Mode
(
DIRECT
or
LATCHED
). Also the colour of the button (cyan) shows that the analogue
mode is now active.
To adjust the analogue Mode, press
ANALOG
on the main screen (Fig. 1, Line 1) or
choose
SETTINGS
and on the following screen
ANALOG
. The
SELECT ANALOG MODE
-
screen (Fig. 6/7) appears.
It is advisable to set the pump (FOG) to 100% to ensure the full output will be used.
If the value is adjusted at e. g. 65%, the connected remote/desk regulates the output
between 0 and 65% as maximum value.
Please note that the selected performance curve/characteristic also effects the amount
of the fog output. Thus - although 100% has been adjusted - the output will eventually
be lower. —> See chapter 5.4.1
