93
the bucket collide with the truck or hopper.
When the bucket is above the truck or hopper, just push down the brake pedal so as
to stop the loader, push rightwards the pilot joystick so as to tilt forwards the bucket, and
then discharge the materials into the truck or hopper. At this time, be sure to carefully
observe the movement of the bucket, and be sure not to make the bucket collide with the
truck or hopper. If the material is very sticky, just push and pull the control handle
repeatedly, so as to make the stopped of the bucket collide with the lift arm repeatedly, so
as to make the materials fall down from the bucket.
If the length of the truck exceeds two times the width of the bucket, the unloading
operation shall be started with the materials on the front portion of the truck.
NOTE: Be sure not to make the stopper collide with the lift arm too violently or too
frequently, otherwise the loader may get damaged.
After all materials are unloaded, just pull the pilot joystick backwards to the limit
position until the control handle is caught up by the electromagnet, and then release the
control handle (the handle will not return to the middle position automatically). The bucket
will turn backwards continuously until it is in the horizontal position, and then the
electromagnet will be de-energized and the pilot joystick will automatically return to the
retaining position. Thereafter, just pull backwards the gear-shifting handle to the reverse
gear position, and then release the brake pedal, so as to make the loader leaves the truck
or hopper.
After the bucket fully leaves the truck or hopper, just lower the lift arm while the loader
the travelling, so as to get ready for the next working cycle.
②
Discharging of materials at lower position
When being handled between different places, sometimes the materials may be
discharged at lower position, which means that the materials are discharged with the
bucket located at a position close to ground. In this case, after the materials are
discharged, be sure to turn backwards the bucket until it is in the horizontal position and
then raise the lift arm, otherwise it is likely that the lift arm cannot be raised up owing to the
interference caused by the linkage of work attachment.
Push-transportation
Place the bucket horizontally close to the ground, set the gear-shifting level at the
position of forward gear 1, and then push down the accelerator pedal, so as to make the
loader move forwards. If an obstacle is found in the course of working, just slightly raise
the lift arm and go ahead. When raising or lowering the lift arm, the pilot joystick shall be
operated between lowering position and lifting position and may not be fixed at lifting
position or lowering position, so as to ensure the smooth progress of the working.
Scraping
Raise up the lift arm until it is about 1100mm above the ground, and tilt the bucket
forwards until its scraper contacts with the ground and the included angle between the
