85
Figure: Inspect the wiring of battery. Connect the
wiring according to the figure.
4.3.2 STARTUP OF ENGINE
1. Clear away the persons around the loader and the obstacles in the travelling direction
of the loader; inspect whether there is any person under the loader; except for the
driver who may sit in the cab for operating the loader, no other person may stand on
any portion of the loader.
2. Turn on the negative pole switch of the battery.
3. Go up and go down the stairs in accordance with the relevant safety provisions.
4. Adjust the rear view mirror, so as to obtain a good rear vision which is as closer to the
loader as possible.
5. Close the left and right doors of the cab.
6. Inspect whether the seatbelt is in good conditions, and then properly fasten the
seatbelt.
7. Inspect whether the gear-shift lever is at the neutral position; if not, please set the
gear-shift lever at the neutral position.
8. Inspect whether the pilot joystick is at the middle position; if not, please set it at the
middle position.
9. Inspect whether the fan switch and A/C switch of A/C system are at the off position; if
not, please set them at the off position.
10. Insert the key into the electric lock and then turn it clockwise by one step so as to turn
on the power supply, and then sound the horn so as to declare that the loader is about to
start up and no other person may approach the loader.
11. Inspect the level of fuel.
12. Slightly push down the accelerator pedal, and turn the key clockwise by one more
step so as to switch on the engine starting motor. Under normal conditions, the engine
can be started up within 10 seconds, and then please release the key immediately so
as to let the electric lock return to the original position.
NOTE: An attempt to start up the engine may not last for more than 15 seconds (the
starting motor may not work continuously for more than 15 seconds), and if the
engine cannot be started up, please immediately release the starter switch, wait at
