90
5) Place the bucket on the ground horizontally, and pull the pilot joystick to the middle
position.
6) Set each switch at the middle position or off position, and then lock up all doors.
7) Apply a thin layer of grease onto the exposed portion of the hydraulic oil cylinder
piston rod.
8) Detach the battery from the loader and place it separately.
9) If the atmospheric temperature may reduce below 0
℃
, please add anti-freezing fluid
into the engine coolant, and make the anti-freezing fluid reach the engine and the
evaporator of A/C system. Alternatively, discharge all water in the cooling system, and
also discharge all water in the evaporator of A/C system.
10) Fix the front/rear frames with the frame fixing rods.
2. During Storage
1) Start up the engine once a month, run each system, and apply lubricating oil/grease to
all moving pins/shafts and the transmission shaft so as to get all moving parts well
lubricated. In addition, charge the battery.
2) Before starting up the loader, wipe away the grease on the hydraulic oil cylinder piston
rod.
3) Apply antirust agent to all portions which may get rusted.
NOTE: If the antirust agent is used indoors, be sure to open doors and windows, so
as to get the place well ventilated and discharge the toxic gas.
3. After Storage
When the loader is to be used after long-term storage, be sure to carry out the following
operations:
Replace the lubricating oil of engine, gearbox and drive axle as well as the hydraulic
oil and anti-freezing fluid.
Apply greases to all moving pins/shafts and the transmission shaft.
Before starting up the engine, wipe away the grease from the hydraulic oil cylinder
piston rod.
4.4 WORKING OF LOADER
4.4.1 PREPARATION BEFORE WORKING
Before the commencement of the working, use the loader to flatten the working place,
remove crowing portions, fill depressions, and remove the ground surface which is wet
