Agility Controller Troubleshooting Guide
Warning:
Risk of Electrical Shock. Severe injury or death can result from electric shock during contact with line voltage wiring and
equipment. Disconnect and lock-out all power sources during installation and service
.
Caution:
Before any work is performed either inside an Agility panel or to any devices interfaced to an Agility panel, all sources of hazardous voltage, both into and out of
the panel must be disconnected. The circuit protectors and/or circuit breakers installed in the Agility panel may not disconnect all sources of power. As Logix
cannot verify the actual installation and any modifications of the control panel, Logix recommends that, at a minimum, all circuits both inside the panel and
interfaced to the panel be thoroughly verified as disconnected and safe with a high quality electrical meter, which is tested to be functional before and after the
verification procedures, before any work is performed on the panel or interfaced devices. Even if all known circuits are disconnected, it is still possible a circuit
may become inadvertently energized from another source.
All work must be performed by personnel who are fully qualified to work on industrial control panels.
Troubleshooting Guide
This Troubleshooting Guide is divided into the following sections:
1. Status LEDs
2. Agility LED Error Codes
3. Power and Circuit Protection
4. Analog Sensors
5. Analog Sensor Calibration
6. Analog Outputs
7. Digital Outputs
8. Networking
9. Restoring Default Settings
Refer to the Agility Panel Layout Drawing to assist in locating components.
Status LEDs
