82
3.12 TRAY WITH ANTI-FALL DEVICE
The tray are equipped with safety system to prevent its extraction out of the
oven.
Inserting check that the anti-fall device (see picture) is always in the back.
The tray are extracted from the oven only if raised before.
3.13 GAS BURNER SERIES 3 FITTING INSTRUCTIONS
The gas burner cap must be placed on its seating
and turned clockwise making sure the two fitting
marks face the pins of the below flame-spreader
(as shown in the picture).
WARNING
An incorrect fitting of the gas ring could
cause the flame to spread inside the gas jet
itself damaging it.
3.14 GLOW PLUGS OPERATING INSTRUCTIONS (ONLY ON SELECTED MODELS)
To switch the gas jets on press the knob and turn it anti-
clockwise; the glow plug will turn bright red and cause the gas
jet’s flame to light.
WARNING
It is recommended not to leave any inflammable materials
on top of the kitchen’s work surface, such as cloths and
grease proof paper, which could catch fire just by pressing
the knob, even when the gas jets are switched off.
Make sure every precaution is taken; by pressing the
knobs the glow plugs will immediately turn on and reach 1300° in temperature.
The glow plugs must not be knocked to avoid damaging them.
TO AVOID BURNS AND INJURIES THE GLOW PLUGS MUST NOT BE TOUCHED WHEN THEY ARE
BRIGHT RED. CHILDREN MUST BE KEPT AT A SAFE DISTANCE.
4. CLEANING
Before cleaning turn off at the mains and leave the oven and burners to cool.
Clean the hob and oven after each use in order to prevent build-ups of stubborn dirt that are
difficult to remove and may damage the surfaces.
To clean the stainless steel, enamelled, and glass parts and the
control panel, we recommend using a sponge or damp cloth with
a non-abrasive cleaner. If spots are difficult to take off, please use
specific cleaning products.
Rinse and dry carefully after the
cleaning
. Do not use steel wool, abrasive powders and corrosive
substances that could scratch.
