58
following installation instructions are observed: the pipe must be longer than 400 mm and
shorter than 1500 mm; it must not exceed 50àC in any point; it is not pulled or twisted; it
cannot be choked and the entire edges, sharp corners or other similar hazards.
Before connecting the non-metallic flexible pipe, the pipe holder
and gasket supplied with the cooker and/or available form the reseller must be fitted to the
pipe/gas train on the back of the cooker.
ONLY FOR MODELS: XR96GV/C, XR96MF/C
For connection to:
-
Methane gas
: the pipe must have an internal diameter of 13 mm, be fitted to the pipe holder
and then blocked with a specific clamp as per current installation standards;
-
Liquid gas (bottle)
: the pipe must have an internal diameter of 8 mm, be fitted to the pipe
holder and then blocked with a specific clamp as per current installation standards. The
bottle must be fitted with a pressure reducer as per current installation standards.
Cookers with bottle cupboard IF INSTALLATION STANDARDS PERMIT
. These cookers are
designed prepared for use with bottle of liquid gas (size Ø 270 mm, height 600 mm). They are
fitted with two attachments for the gas connection: one inside the cupboard and one on the back
hand side. The bottle cupboard attachment is sealed with a cap and a gasket, while the other
end is open. If the bottle cupboard attachment is used, the cap must be replaced with the pipe
holder must be connected with a flexible pipe, which must follow the route shown in the
adjacent diagrams and/or on the adhesive plate fitted inside the bottle cupboard door. After
connection, ensure that there are no gas leaks by using a specific instrument or soapy water.
1.5. CONNECTION TO THE ELECTRICITY SUPPLY
In case it should be necessary to replace the power supply cable, please note that the correct
type to be used for connection to the network is: H05VV-F 3x1.5 mm
2
(external diameter max.
9mm), in the case of power higher than 16A the cable must have a
2.5 mm2 section. Leave the cable long enough to allow easy
maintenance; the earth wire (yellow-green) once fixed to the
electrical system terminals, must be at least 2 cm longer than the
other 2 cables (phase and neuto). This device ensures electrical
safety, in the event that the power cord is accidentally torn out.
A defective power cord must not be repaired, it must be replaced
with a cable equivalent to the one indicated above.
The replacement of the power supply cable must be carried out by
the authorised LOFRA technical assistance or by specialised
technical personnel.
