Loewe bild 1, User Handbook Manual, Page: 96 / 227

Loewe bild
User handbook
96
„
System settings
Channels
Search for/update channels – handling of new and no longer
found channels
After the automatic search/update has been concluded, the number
of newly found TV and radio channels is shown.
Call list of new TV channels found.
Select channel.
OK Mark / unmark channel.
Stores the marked TV channels.
Afterwards, a list of the channels which are saved but
which are temporarily not broadcasting or no longer
exist is displayed, if available.
The number of the memory location used is displayed
in front of the channel. Please select the channels you
really want to delete.
Select channel.
OK Mark / unmark channel.
Proceed. The marked TV channels will be deleted.
Subsequently the process of Newly found chan-
nels / Channels no longer found shall be carried
out in the same way for the radio channels.
Back: Close search assistant.
Manual Scan TV / Radio
Here, you can enter all the settings available for a channel. However,
this requires detailed knowledge.
The manual search of radio channels is similar to that of TV channels.
Therefore, the manual search for radio channel is not dealt with
separately.
Calling manual search
HOME: Call Home view.
Mark System settings ,
OK call System settings .
Mark Channels ,
go to next column.
Mark Manual Scan (incl. antenna status) ,
OK call Manual Scan.
Select the menu item Signal source to decide in which
area you want to search for channels.
Depending on the selected source, various setting
possibilities will be available.
On the next page, the settings for analogue cable and
DVB-T/C/S sources are described separately.
Status bar for manual search
Status bars are displayed for manual search, which
show the reception quality of the individual channels
during the channel scan. The markers in all bars should
preferably be in the green area.
C/N: (Carrier/Noise) The bar shows the signal-to-
noise ratio. The value indicated in dB should be
preferably high.
Level: The bar shows the receiving level of the channel.
The value displayed in dBμV should be preferably high.
BER: (Bit Error Rate) The bar shows the bit error rate
of the channel. The value for BER should be as low as
possible.