Loewe bild 1, User Handbook Manual, Page: 55 / 227

Loewe bild
User handbook
55
„
Recordings
Digital Recorder
Subtitles
Subtitles (DVB subtitles) of a program can also be saved during
recording.
The recording of subtitles in DR+ continuous mode must be
activated in the settings.
It is not possible to record teletext or HbbTV subtitles.
Calling up the subtitles during a later playback is similar to calling
subtitles in TV mode.
Timer-controlled recording
Comfortably select your favourite programme for recording from the
EPG. The timer overview has room for 50 entries.
You will find further information on timer-recording in chapter
Recordings , section Timer .
Switching off the TV set during recording
You can switch off the TV to standby whilst recording. The recording
is continued in the standby mode.
Never switch the TV set off at the mains and do not pull the plug
of the TV set out of the socket. Otherwise the recording will be lost!
Stop recording early
You can end a current archive recording prematurely.
Press STOP key .
A message appears in the right upper corner of the
screen.
OK Stop recording.
The recording process is ended. The portion of the TV
broadcast recorded up to this point is saved on the
hard disk and can be played back via the DR+ archive.
If two archive recordings are active (multi record-
ing
(1 ), the recording stops that started first.
You can also end a running recording by deleting the
corresponding Timer entry in the Timer overview
(see chapter
Recordings , section Timer ).
Multi recording (1
The Multi Recording function makes it possible to record two pro-
grammes at the same time and still watch a third one as well.
Generally speaking: each recording, each selected channel requires
one transponder stream. With dual channel devices, two separate
streams are available.
An ideal scenario is to record from two channels sharing one tran-
sponder, so that any third programme can be watched.
While simultaneously recording from two programmes that are on two
different transponders, only those channels are selectable for the third
programme, which are transmitted by one of the two transponders.
All channels that are on other transponders appear in the channel list
in dark grey and cannot be selected.
In order to use the full range of functions of multi-recording, two
antenna cables must be connected when using DVB-S or 2 chan-
nels must be configured for a DiSEqC single-cable system.
Recording of analogue channels is not possible.
Recordings of CI Plus encrypted programmes (e.g. RTL HD, Sat 1
HD, Pro 7 HD, etc.) are perhaps not possible or only to a limited ex-
tent. In order to use the full range of functions of the multi-recording,
two CA modules must be used.
The examples shown in the following table for channel combina-
tions are valid only for DVB-S. For DVB-T or DVB-C, other combina-
tions may apply.
The channel / recording combination that can be used, depends
on the respective channel group / transponder group. You get
the assignment from your network provider or the respective
broadcasting channels.
Examples of DVB-S recording combinations:
Broadcasting channel
combinations: Possible: Info
Recording Sat 1
Recording Pro 7
Watching any of the channels Yes Transponder 1: Sat 1, Pro 7
Transponder 2: vacant for select-
ing any channel
Recording Sat 1
Recording RTL
Watching any of the channels No Transponder 1: Sat 1
Transponder 2: RTL
You can not choose any chan-
nel, only one channel on one of
the transponders used e.g. Vox,
Pro7, RTL2.
Recording ARD HD
Recording ZDF HD
Watching arte HD Yes Transponder 1: ARD, arte HD
Transponder 2: ZDF HD
Recording RTL
Recording RTL II
Watching ARD HD Yes Transponder 1: RTL, RTL2
Transponder 2: ARD HD
Recording RTL
Watching ARD HD
Watching ZDF HD No Transponder 1: RTL
Transponder 2: ARD HD
ZDF HD is on a different tran-
sponder, and therefore can not
be displayed.
Multi recording
(1
Availability varies by device type (see chapter Technical data - equipment features for your TV set).