Loewe bild 1, User Handbook Manual, Page: 149 / 227

Loewe bild
User handbook
149
„
Teaching the remote control
Teaching the remote control
By means of key code 18 (Set-Top Box data base) your remote control
Loewe assist may be taught for your Set-Top Box (e.g., decoder, ex-
ternal cable tuner). Thus, you spare yourself the use of several remote
controls.
The following options are available for teach-in:
- Entering a 3-digit code number
- Read-out of the programmed Set-Top Box code
- Teaching individual keys
- Delete learned codes
In the following, the STB key is dealt with as an example. Code 18
may also be assigned to the VIDEO and AUDIO keys; the following
description applies accordingly.
Programming with set button with button code 18
For the use of 2-digit key codes see chapter External devices ,
section Setting the remote control .
Press set button STB and at the same time STOP
button for 5 seconds, until the corresponding LED
indicator flashes twice.
Enter set code 18 .
The associated LED indicator flashes twice.
Entering a 3-digit code number
The STB key can be programmed directly by means of a device-
dependent 3-digit code. You find a list of these codes in chapter Code
page at the end of this user handbook.
The STB set button must be programmed with
button code 18.
Keep the STB and OK keys depressed for five seconds.
The LED above the STB key flashes twice.
Enter the 3-digit code from the list. The LED above the
STB key lights up for 1 second.
OK end the programming mode. After a successful
programming the LED flashes twice.
When entering a wrong code number, the LED lights
up for 2 seconds. Do this programming once again.
Read-out of the programmed Set-Top Box code
The code of the currently programmed device on the STB key can be
indicated by the remote control.
The STB set button must be programmed with
button code 18.
Keep the STB and OK keys depressed for five seconds.
The LED above the STB key flashes twice.
Press INFO key.
The LED above the STB key shows the programmed
code by flashing. The figure "0" will be indicated by
flashing 5 times.
Teaching individual keys
All keys (except the TV , STB , VIDEO and AUDIO device keys as well
as the V+/- keys and ) can be taught for the operation of units
which are not contained in the integrated data base. The functions of
the selected button are then completely or partially overwritten with
the new codes.
Place the TV remote control and the remote control to be replaced
in such a way that the infrared windows face each other at a distance
of 1-5 cm (see sketch).
Preparation:
The STB set button must be programmed with
button code 18.
Keep the STB and the red key simultaneously
depressed for five seconds.
The LED above the STB key lights up permanently.
Learning function:
Press key to be taught on the TV remote control.
The LED above the STB key flashes.
On the original remote control press the button which
is to be taught.
The LED above the selected STB key flashes twice.
If the code is not correctly recognised, the LED above
the STB key flashes ten times.
Then repeat your entry on the original remote
control. If necessary correct the allocation of the two
remote controls.
Continue with the other buttons as described above.
Terminate learning mode:
To end the teaching mode, press the STB key again.
After 10 seconds without an entry the teaching mode
is automatically terminated.
It is possible that not all remote control codes can
be taught.
1-5 cm