Loewe bild 1, User Handbook Manual, Page: 134 / 227

Loewe bild
User handbook
134
„
System settings
Connections
Antenna DVB
Here you can make settings for the DVB-T antenna and call the antenna
wizard for the DVB-S antenna.
Call Antenna DVB
HOME: Call Home view.
Mark System settings ,
OK call System settings.
Mark Connections ,
go to next column.
Mark Antenna DVB ,
go to next column.
Select the desired setting,
call.
Explanations of the setting options in the antenna DVB menu:
Terrestrial
(DVB-T/T2)
Here you can set whether your DVB-T antenna needs
a supply voltage.
Antennas with an integrated amplifier need a supply
voltage on the antenna line. In this case, select
Supply voltage 5V and confirm with OK .
Otherwise, select No supply voltage and confirm
also with OK .
Satellite
(DVB-S/S2)
Here the antenna wizard starts guiding you through
all the settings relevant to the DVB-S antenna. The
settings of the DVB-S antenna wizard are explained
in the procedure of initial installation.
SAT>IP Here you can select from which servers you wish to
receive your channels.
Positioning/aligning DVB-T antenna
If you are receiving one or more DVB-T channels with picture and
sound interference then you should change the installation location
and alignment of the antenna. Find out online which channels are
broadcasting the DVB-T channels in your region.
A DVB-T channel is received and selected.
Calling manual search (see chapter
System settings , section Chan-
nels – Manual TV/Radio scan ).
Due to the preset channels, the signal source is already selected as
DVB-T. Position and align the antenna so that maximum
C/N values
and levels are reached.
Search for DVB-T channels one after the other and compare values
for
C/N and Level . Then position/align the antenna to the weakest
channel so that maximum values for C/N and Level are obtained.
The value for BER should be as low as possible.
Thereafter, perform an automatic search for all DVB-T channels.
AV connection settings
In the AV connection settings menu the parameters for the AV
connection socket can be adapted.
Calling the connections menu
HOME: Call Home view.
Mark System settings ,
OK call System settings.
Mark Connections ,
go to next column.
Mark AV connecting settings ,
go to next column.
Select the desired setting,
call.
Explanations of setting possibilities in the AV connecting settings
menu:
Device at
connection
AV
Indicate here whether a set and, if yes, which one is
connected to the
AV socket.
Signal type You set the signal type of the device connected to AV
here. You can find out more from your dealer.
Allow
switching
voltage
If this function is activated, the video and audio of an
external unit connected to the
AV connector (not at
AVS) will immediately be reproduced on all TV broad-
cast sites when playback is started up, provided that
the external unit supplies a switching voltage.