Loewe bild 1, User Handbook Manual, Page: 21 / 227

Loewe bild
User handbook
21
Initial installation wizard
Initial installation after switching on for the first time
The Initial installation wizard starts automatically with an initial
installation. It may be called repeatedly again (see chapter
System
settings ,section Extras – Repeat initial installation ).
If a parental lock is activated, the access code must be entered
before repeating initial installation (see chapter
System settings ,
section Control – Parental lock ).
For information on navigation within the wizard refer to chapter
General information on menu operation .
First installation wizard routine
The selected settings affect the routine of the Initial installation wizard.
Select desired Menu language .
OK Confirm selection.
Selecting the language of the user guidance is the
wizard’s first step. Then you simply follow the
instructions on your TV screen.
Proceed to next step.
A licence agreement will be displayed.
Select Confirm .
OK Confirm the licence agreement and proceed to
the next step.
Select Energy efficiency.
OK Confirm selection.
Determine how energy efficient your TV set shall
be. The value for the contrast (and thus the
brightness of the background lighting) is adapted
and the automatic dimmer activated or
deactivated depending on the presetting.
The automatic shutdown is active in the mode
Home Mode and Premium mode .
Menu
language
Energy
efficiency
Home mode:
The emphasis for home use is on low energy
consumption. The automatic dimmer is activated.
Premium mode:
This mode optimises the settings to a brighter
environment at a higher energy consumption. The
automatic dimmer is activated.
The use of this energy efficiency setting must be
confirmed afterwards once again.
Shop mode:
The picture settings are aligned to operation in
the presentation room. The automatic dimmer is
deactivated. If the ambient brightness diminishes, the
energy consumption is not reduced.
The use of this energy efficiency setting must be
confirmed afterwards once again.
Not all image and sound settings will be stored in
the shop mode. These settings will be reset to the
factory default settings after re-starting.
The presetting can be changed later in the System
settings under Control
ט
Energy efficiency .
Proceed to next step.
Select Location of TV set (national defaults
are adopted).
OK Confirm selection.
For certain locations (e.g., Australia), there is finally
a selection screen where you can indicate in which
state/territory the device is being operated.
Proceed to next step.
Select the Operating mode .
OK Confirm selection.
Use the TV set as a TV set :
Continued with Connect antennas cable(s) (see
next page).
Use the TV set just as a monitor :
see chapter Initial installation , section TV set as a
monitor .
Energy
efficiency
(continued)
Location of
TV set
Operating
mode
„
Initial installation