LNS QUICK SIX S2, Instruction Manual

Page: 9 / 83

CHAPTER 1: BASIC NOTIONS 7
MOVE S2
Do not handle the equipment without having
knowledge of the safety instructions and the
instructions for use. Safety instructions for
the bar feeder, as well as the CNC lathe,
must be strictly observed.
Non-qualified personnel, children, and
persons under the influence of alcohol or
medication
should not handle the
equipment.
Loose garments, long hair and jewelry can
be dangerous.
Do not remove any covers while the bar
feeder or the machine is under electrical
power.
Do not conduct any maintenance operations
during the automatic cycle.
Do not grasp moving or rotating objects, or
nearby elements.
If certain safety shields or safety covers are
removed to conduct maintenance, they must
be reinstalled as soon as the maintenance
work is completed.
No servicing should be carried out on the
interface or inside the electrical cabinet while
the bar feeder or the lathe is under electrical
power.
It is strictly prohibited to jump wire or remove
circuit
breakers, main switches, and
especially safety switches.
To avoid any harm to persons, or damage to
components, use only the indicated points
for lifting and moving the bar feeder. No one
should be near the hanging load, or within
the operating range of the overhead
hoist/crane, forklift, or any other means used
for lifting and transportation. Do not knock
the bar feeder while moving it as this could
damage it.
Do not move the bar feeder while it is
electrically powered on.
The work area surrounding the bar feeder
should always be clear of objects and well lit.
The presence of oil on the ground could
cause falls; it is important to maintain the
floor clean on a regular basis.
Do not place the machine in a damp area
and make sure that water or oil does not
come into contact with the electrical
equipment.
Do not open the clamping device (collet or
chuck) of the lathe manually when the bar
feeder is in automatic mode (Interface).
Each time the diameter is changed, also
adapt spindle reduction tube. The use of
spindle
reduction tubes is highly
recommended for machining bars with
diameters
smaller than the maximum
capacity of the spindle.
Do not attempt to recharge the batteries of
the PLC.
For the use and maintenance of the bar
feeder, use only parts provided by or
recommended by LNS.
If it is necessary to move the bar feeder once
it has been originally installed, do not reinstall
it before first contacting LNS or its local
representative.
The rotating bar should never protrude the
rear of the lathe spindle.
The maximum length (max. L) the bar feeder
is allowed to load is given by the length of the
lathe spindle. The bar should never extend
more than 3 times its diameter beyond the
lathe clamping device without support.
LNS disclaim all responsibility for possible
accidents or property damage caused when
safety instructions are not followed.