LNS QUICK SIX S2, Instruction Manual

Page: 20 / 83

18 CHAPTER 3: SETTING INTO OPERATION
MOVE S2
Please read the safety precautions described at the beginning of this manual before
handling the following devices.
Depending on its destination, the MOVE S2 bar feeder may be delivered either on a pallet, or packed in a
wooden crate. When sea or air transports it, the second solution is recommended. Regardless of the type
of packaging, the uncrating and lifting instructions recommended by LNS must be observed in order to
prevent any injuries to persons and damages to objects. These instructions are stapled to the crate of the
bar feeder.
Width 1110 mm 1000 mm
Length 3800 mm 3800 mm
Height 1680 mm 1400 mm
Check to see that the lifting capacity of the hoisting crane, or lift truck, is adequate before
proceeding with the handling of the merchandise. No one should be near the hanging load,
or within the operating range of the overhead hoist/crane, forklift, or any other means used
for lifting and transportation.
1) If the bar feeder is received in a crate,
start by unscrewing the front panel.
2) Remove the top.
3) Remove the side-walls.