52
CHAPTER 4: OPERATION
MOVE S2
This parameter allows to adapt the language in which the
messages will appear, depending on the country of destination of
the bar feeder
.
This parameter defines whether the measures will be indicated in
millimeters or in inches.
This operation allows the bar feeder to find the original position of
the servo motor and the parameters when and if these have been
lost.
The interface signal is reversed depending on whether the
clamping device functions by pushing or by pulling. It is therefore
essential to know the operation of the clamping device, without
this, the feeding process cannot be done correctly.
This is the time it takes for the clamping device to be physically
closed. The majority of CNC lathes are equipped with confirmation
switches to provide this signal. The time is set at a default value of
zero seconds.
In the case of a clamping device with jaws, sometime may be
provided to prevent any movement before the clamping device is
completely open.
Summary of Contents for QUICK SIX S2
