Lissmac CC401 E, Operating Manual

Page: 13 / 48

13/48
2.4.2. Commissioning
Protect hands from sharp edges when fitting the saw blade.
Ensure that the ground/floor has adequate load-bearing capacity. All obstacles must be removed from
the cutting area and good lighting must be provided.
Visually check the floor saw for damage and defects. Check the safety set-up in particular.
Provide a water supply to cool the saw blade.
The power supply must be equipped with a correctly dimensioned, functioning ground fault circuit
interrupter/RCD
The connection cables and plugs must be adequately dimensioned and in good condition.
Defective or cracked tools must be replaced immediately.
2.4.3. Operation
Refrain from any unsafe working procedures.
Implement measures to ensure the floor saw is only used if it is safe and functional.
Check the floor saw for outwardly recognizable damage and defects prior to every shift! Notify the
responsible place/person immediately of any changes (including the operational behavior)! Switch off
the machine immediately if necessary and secure it against restarting.
In the event of malfunctions, shut down and secure the floor saw immediately! Have faults repaired
immediately. Electrical work may only be carried out by trained electrical personnel.
Only use appropriate, tested tools.
To protect against acceleration, the saw blade depth feed must be driven into the substrate slowly and
in steps. Avoid any contact with the rotating tool. Maintain a safety distance of 1.5m from the saw
blade.
Do not cut without a saw blade guard.
The operator must be protected from rotating parts.