English
English
14
Burnback Time
is the amount of time that
the weld output continues after the wire
stops feeding. It prevents the wire from
sticking in the puddle and prepares the end of the wire
for the next arc start.
••••
Factory default, Burnback Time is set at 0.07
seconds.
••••
Adjust range: from OFF to 0.25 seconds.
OFF
0.25
M
t2
t1
0.07s
Figure 20.
Spot Timer
– adjusts the time welding will
continue even if the trigger is still pulled.
This option has no effect in 4-Step Trigger
Mode.
••••
Factory default, Spot Timer is OFF.
••••
Adjust range: from 0 second (OFF) to 120 seconds.
Note
: Spot Timer has no effect in 4-Step Trigger Mode.
OFF
120
t2
t1
OFF
t
Figure 21.
Run-in WFS
– sets the wire feed speed
from the time the trigger is pulled until an arc
is established.
••••
Factory default, Run-in is turned off.
••••
Adjust range: from minimum to maximum WFS.
OFF
17.78
OFF
M
t1
t2
Figure 22.
The Start Procedure controls the WFS and
Volts (or Trim) for a specified time at the
beginning of the weld. During the start time,
the machine will ramp up or down from the Start
Procedure to the preset Welding Procedure.
••••
Adjust time range: from 0 seconds(OFF) to
10 seconds.
OFF
10.0
OFF
M
t1
t2
Figure 23.
1.0s
M
t1
t2
min
m
10.00
v
31.6
Figure 24.
