English
English
16
M
M
Figure 29.
••••
Press the Set Control [11].
••••
Use the Set Control [11] to highlight the Memory
Number which from the Welding Program will be
recall.
••••
Confirm the select – press the Right Button [12].
Note:
If the parameters saved in the program memory
are highlighted on red (figure 30) it means that the unit of
the workpoint and/or trim in Setup Menu is not the same
as the unit of these parameters saved in the program
memory. In that case, after the welding program is
recalled, the parameters marked on red will be changed.
To restore the units compliances, enter to Setup Menu
and set the parameters P.28 and/or P.20 accordingly.
M
v
20.0
min
m
7.62
1 2 3
4
5 6
7 8
9
94
ArCO2
Steel
0.8
Figure 30
Additionally,
the Setting and Configuration
Menu
can be also entered from the User
Settings Menu. Full description
the Setting
and Configuration Menu
in Section 3.10.
Note:
The Setting and Configuration Menu icon cannot
add to the Welding Parameters Bar [27].
To go to the Setting and Configuration Menu from the
User Settings Menu:
••••
Access to the User Settings Menu.
••••
Use the Set Control [11] to highlight the Settings and
Configuration Menu icon.
t2
A/B
M
Figure 31.
••••
Press and hold for 1 second the Set Control [11].
t2
A/B
M
Figure 32.
••••
The Settings and Configuration Menu is shown on
the display.
?
MIN
MAX
100
10
50
Figure 33.
