Lincoln Electric MASTERPIPE Mini Profiler, Installation And Operation Manual

Page: 46 / 106

38
MASTERPIPE
®
Mini Profiler
Step 19: Connect CNC cable to CNC Controller
The plasma cutter’s CNC interface cable connects to the relay terminals of the Torchmate
CNC Controller. This connection allows the CNC Controller to operate the plasma cutter’s
plasma arc under CNC control.
Qty Part Description Part #
1 Pro-Series CNC
Controller From Step 13
1 CNC interface cable (Supplied with
your plasma
cutter)
Required parts /
components
Instructions • The plasma cutter CNC interface cable provides a pair of wires
(labeled 3 and 4 or colored green and black) that should be
connected to the relay terminals on the CNC Controller.
• You may have to cut off existing lug connectors and strip the
insulation from the wires to insert them into the terminal connectors
on the CNC Controller (this is the normal procedure).
• Tighten the screw to provide electrical and mechanical contact. The
terminals shoud grip the wire and not the insulation and the insulation
should not be stripped back so far that bare wires can make contact.
• Note: if you have an AVHC torch height controller, the wiring is
different. See Step 15.
Illustration
The CNC Interface cable’s wires 3 and 4 or
Green and Black go to the Relay connec-
tor. The wire ends should be stripped,
inserted in the connector, and screwed
down tightly.