Lincoln Electric K2532-1, Operator'S Manual

Page: 20 / 118

INSTALLATION
7. G uide straightened wire through inlet
wire guide and toward drive roll
groove.
FIGURE A.11
8. While holding o p en the idle roll, slide
end o f wire through drive roll ʼ s
groove and toward gun tube liner.
FIGURE A.12
9. Slide the wire into the liner until it
extends a pp roximatel y 1 inch be y ond
the end o f the gas di ff user. R elease
idle roll tab without sna pp ing it.
FIGURE A.13
10a. Allo y 404 3 : R oll u p remaining wire
back onto s p ool and p lace s p ool
onto gun s p indle. Install locking
knob and f inger-tighten. G o to ste p
11.
FIGURE A.14
10b. Allo y 5 3 56: Install Conical S p ring,
small end f irst, onto gun s p indle
( A ) . R oll u p remaining wire back
onto s p ool and p lace s p ool onto
gun s p indle. Install locking knob
and f inger-tighten.
FIGURE A.15
11. G ras p the f ree end o f the wire at the
gas di ff user and slowl y p ull a pp roxi-
matel y 12 to 24 inches o f wire
through the s p ool gun. There should
onl y be 1 to 2 lbs. o f resistance. I f
f orce is greater than 2 lbs. wire is
binding in the gun ( also see
Troubleshooting guide ) .
FIGURE A.16
A
A-12