Lincoln Electric K2532-1, Operator'S Manual

Page: 19 / 118

INSTALLATION
A-11
LOADING ALUMINUM WIRE
1. R emove gas cone and contact ti p .
R emove s p ool cover b y unscrewing
ca p tive locking knob.
FIGURE A.5
2. R emove locking knob f rom s p indle
bolt b y unscrewing it.
FIGURE A.6
3 . Select wire allo y and diameter need-
ed. Allo y 404 3 and 0.0 3 5 wire si z e
shown. R emove p ackaging and data
sheet f rom wire s p ool.
FIGURE A.7
4. Extend a pp roximatel y 12 inches
o f wire f rom s p ool. Straighten it
out b y back-bending it. Use care
to p revent the wire f rom dereeling.
FIGURE A.8
5. Cut o ff bent end o f wire, leaving
straight section.
FIGURE A.9
6. G entl y p ull o p en the idle roll
assembl y to ex p ose the drive roll
groove.
FIGURE A.10
Allo y
Si z e