LINCHR H Series, User Manual

Page: 12 / 90

10
6. Installation
The following content describes the installation process of the charger.
It must be carried out by professionals.
6.1 Installation conditions and environmental requirements
The charger can be used outdoors. The charger must operate in the environment required by the manual,
otherwise the life of the charger will be affected. The installation and operation of the charger must meet the
following conditions:

The ambient temperature of use must be -25
℃
~ 50
℃
;

Humidity ≤ 95% RH;

The installation position shall not have strong vibration or mechanical impact;

The charger must be kept away from explosives or dangerous goods, conductive medium and harmful
gas;

The charger must be clean, free from mildew, away from wet dust, flammable and explosive gas and
liquid, away from heat sources and corrosive environment;

The installation altitude of the charger is ≤ 2000 meters.
6.2 Accessories for installation
The following accessories are required for the charger installation:

User manual (1 copy, see the charger accessory bag);

Expansion screws (4 sets for CASE B version and 7 sets for CASE C version, see the charger accessory
bag), which are used to fix the charger on the wall and the charging charging cable hanging device;

Positioning cardboard (1 piece, in the charger packing box) for positioning the wall surface mounting
hole;

Back pegboard (1 piece, fixed on the back of the charger already), it need to be disassembled from the
charger to fix it on the wall/pedestal when the official installation starts;

Charging cable hanging device (1 piece, in the charger packing box), used for CASE C to wind charging
cable.
6.3 Install short-circuit protection device