LINCHR H Series, User Manual

Page: 62 / 90

60
Stop charging
10.2 Start/stop charging through RFID card
When the charger is reliably connected to the electric vehicle, place the RFID in the card swiping area of
the charger (AREA1), and it shall be close to the card swiping area as far as possible. When the buzzer
generates the "beep" sound, the LED lamp of the charger changes from the "blue lamp always on" to the
"blue lamp flashing", and the charger starts charging the electric vehicle.
If you need to stop charging, please place RFID close to the card swiping area again (as close as possible
to the card swiping area), and the buzzer generates the "beep" sound, and the charging session is finished.
At this time, you can unplug the charger.
Warning: When swiping the card to start charging, if the buzzer generates the "beep" sound twice
(the interval is about 0.5s), it means that the RFID card is not authorized!
10.3 Start/stop charging through platform
The platform starts and stops the charging according to OCPP1.6J standard flows. Before the platform
issues the starting command, please ensure that the car is reliably connected to the charger.
10.4 Schedule charging
"Schedule charging" can be set in the mobile APP. When the scheduled charging time starts, the charger
automatically starts charging, and the charging current is the maximum current under load balancing
adjustment. The red column time period in the following figure is the scheduled charging time period.