23
8
Wiring of power cord:
Remove the power supply protection
cover;
Measure the length of the power cord,
strip the power cord, and conduct
crimping between the top end of the
stripped cable and the tube-shaped
terminal, if it is 6mm
2
cable, it is
recommended to use a 6012
tube-shaped terminal;
Remove the waterproof gland and
fastening ring, and the power cord
passes through the waterproof gland
and fastening ring;
Connect the power cord according to
the marks on the sealing cover;
Install the power supply protection
cover;
Install the sealing cover, and fix it
reliably with one screw;
Install the exterior trim cover, and fix
it reliably with one screw;
The installation of the charger is
completed!
Summary of Contents for H Series
Page 1: ......
Page 60: ...58 ...
Page 63: ...61 ...
Page 81: ...79 13 1 4 The interface of successful or failed upgrade is shown in the figure below ...