Page 34 / 129
Section
4
.
Operation
Important:
New IP settings can be applied while an active connection is alive on the Ethernet port but
in this case the active connection will be closed automatically. To reconnect the Ethernet
port needs to be used again.
Info:
If you get ,,OPERATION FAILED” message then please disconnect the remote TCP/IP
sockets and try again.
Exit without save
To discard changes execute
‘Exit & no save’. To do this,
navigate to this item with the left
◄ and right ► buttons, then
press ENTER
.
Power status
Navigate to this menu in the main menu list and press
ENTER
. The monitored voltage levels (nominal 3.3V and
nominal 5V) and the temperature of the main processor are
shown on the LCD panel. String to be shown is longer than LCD
display line. Wait a second and the string will be shifted to left
character by character.
No changes can be made here. Press left
◄ and right ►
buttons to select another menu item.
Firmware versions
Navigate to this menu in the main menu list and press the up
▲ and down ▼ buttons to
view the desired firmware version number. Press left
◄ and right ► buttons to select
another menu item.
RS-232 settings menu
The serial port baud rate value can be set here. Press the
ENTER
and use the up
▲ and down ▼ buttons to change
the baud rate value. Changes take place when ENTER
is
pressed.
A beep sound and the ‘Operation done!’ message
indicate that the protocol is changed.
View log menu
Navigate to this menu in the main menu list and press
ENTER
Use the up
▲ and down ▼ buttons to toggle
between the notices.
System events and errors can be checked in this menu. Use
the up
▲ and down ▼ buttons to scroll between the log entries.
The first line of each log entry shows the current entry number,
number of all entries, and the level of the current entry. The
second line is the name of the event that created the entry. The
third line shows a hexadecimal parameter and an occurrence
counter. The occurrence shows how many times the event
happened since the last startup.
Press the ENTER
button to return to main menu.
Exit & no save
Power status
3.30V 5.01V 31.4
Firmware: CPU
1.0.9
Firmware: WEB
1.0.3
Firmware: SERVER
2.0.4
RS232 baudrate..
57600,8,N,1
View log...
0 error
1/2 Notice
BOOT p:0x00 o:1
2/2 Notice
READY p:0x00 o:1
Power status
3.30V 5.01V 31.4
Power status
.30V 5.01V 31.4C
Operation
Done!
