LightPointe AireLink 60, Installation And User Manual

Page: 65 / 133

AireLink

60 Installation and User Manual Rev. D System Installation
Page 65
c. After starting the application, the software will automatically scan for AireLink systems.
To find the system the line-of-sight distance between the phone/tablet and the AireLink
system should not be more than 300 feet (100 meters). Distances will be shorter in case
of an obstructed view. After successful discovery, click the AireLink system you would
like to connect to. When asked, please enter the default passcode 0000 to finalize the
connection. (
Note: This code can be changed later using the web browser interface to
preclude non authorized system access.) Open the application RADIO tab and observe
the RSSI value.
4. Verify that the RF ON LED is lit (green) on both radio heads.
5. Most likely at this point there is no connectivity established between the radios and RF SYNCH
LED will be off. Depending on the status and wiring of additional networking connections there
might be other data port LEDs lit, too. However, these are not essential for the alignment
process and the system can be aligned without an active network connection being present.
6. In case you bought the optional Alignment Sight Tool, please
attach it to either side of the radio enclosure as shown in Fig.
5-5. The Alignment Sight Tool does not eliminate the need for
precise adjustment of the antennas, but it shortens the time
it takes to correctly point the antenna towards the remote
antenna locations.
Figure 5-5: Alignment Sight Tool (Integrated Antenna System)