TruScan 532 Single - Wavelength – Operators Manual Rev. No 02
Page 63 of 114
If the outer cardboard packaging looks without any physical damage then you can
proceed to remove the internal packed assemblies (refer to Fig. 5.1). The contents of
each layer are:
1.
The top layer is just a protection layer.
2.
The middle layer contains the Chinrest and Integrated LDU including the delivery
housing, binoculars, eyepieces, target rod, target plate, upper arm housing,
lower base housing, dust covers, spare lamp, manual, delivery fiber, fiber holder,
mains power cable and delivery fiber.
3.
The bottom layer part contains the LCD control panel and arm holder.
The packing checklist is used to confirm the individual layer contents and notify the
manufacturer if any discrepancy. The motorized table is an optional and may be
purchased from the manufacturer.
5.3
Tools and Equipment
In order to be able to effectively carry out a full initial installation of the Green Laser
System the following tools and equipment are required and available from the
manufacturer:
1.
Laser Power Meter (to measure from 0 to 10 watts CW)
2.
Optical Alignment tool kit, which includes:
Model Eye
Laser target tool
3.
Photographic thermal paper (Zap-it or equivalent)
4.
Set of metric Allen keys
5.
Screwdrivers (Philips / Roberson)
It is both essential and mandatory to have the all above listed tools and equipment in
order to assemble or disassemble Lightlas in a correct and safe way
