Lighthouse REMOTE 3104P, Operating Manual, Page: 49 / 82

Ethernet Installation
248083336-1 Rev 3 6-7
9. Activate the 3104P or 5104P Ethernet interface by typing, telnet
xx.xx.xx.xx 1 (replace x’s with the IP address to be used for the
3104P or 5104P) and press Enter . This command will cause a
connect error but is required to establish communications.
Figure 6-5 Telnet 1
10. Type telnet xx.xx.xx.xx 9999 and press Enter . This command
accesses the telnet port of the 3104P or 5104P. The expected
error message from Step 9. is shown in the example screen below.
Figure 6-6 Telnet 9999
You will have 4 seconds to respond in the next step. If you respond
too slowly, you’ll have to repeat step 10.