Lighthouse REMOTE 3104P, Operating Manual, Page: 47 / 82

Ethernet Installation
248083336-1 Rev 3 6-5
Cross-over Cat5 Setup:
1. Attach one end of the cross-over cable to the RJ45 receptacle on
the PC.
2. Attach the other end of the cable to the REMOTE 3104P or
5104P Ethernet Port.
3. Apply power to the instrument. Apply power to the PC if it is not
already running. Observe the LEDs on the hub/switch RJ45
connector - blinking indicates network activity. Observe the
network LEDs on the 3104P or 5104P RJ45 receptacle - they
should blink indicating activity. Proceed to next section.
Program the
Interface
Windows Telnet Programming:
1. Start Windows.
2. On the Taskbar, click on
Start
.
WARNING:
Perform
only the steps or
commands as provided
in this guide. Failure to
heed this warning can
result in damage to
equipment, personal
injury or data loss and
may void the equipment
warranties.
3. Select
Run
.
Figure 6-1 RUN Screen
4. In the Run window, type CMD and click OK.