Lighthouse ApexP3, Operating Manual, Page: 74 / 130

Lighthouse ApexPortable Operating Manual
5-44 248083440-1 Rev 5
• If Auto Increment is enabled, the user will be prompted to move the
particle counter to the next assigned location after the current
location’s number of cycles are completed.
• After all of the required samples have been completed, the
instrument will prompt the user to Save the Report Session as
shown in Figure 5-67.
Figure 5-67 Save Reports Prompt
Set Up Report Room Parameters
When one of the report options buttons is pressed, the instrument uses
the current Room Area, Class Level, Air Flow and Room Status
parameters to determine the minimum number of locations, samples
and volume per channel in order to classify a cleanroom with that
standard. Use the displayed minimum values to configure the
instrument so that the minimum requirements needed to classify the
cleanroom will be met. Perform the following steps to set report
parameters:
Figure 5-68 Report Setup Step 1
• Press the desired report button then press the SETUP button shown
in Figure 5-68.